construction steps
(1) Embedding pp tiles in the site needs to observe and deal with the ground in advance. The ground is flat and free of protrusions and sags. The cement floor or asphalt floor needs to be cleaned up, and there must be no sundries affecting the installation. The entire floor needs good shock absorption and uniform stress, so the foundation must be handled well before construction. With the conditions, it is much simpler to install it, just buckle each piece together.
(2) After it is placed in the floor, it is necessary to attach side strips to the site. Our factory distributes these to customers. This varies from person to person. Some customers will use it if they like it beautiful. After adding side strips, some stretching areas need to be vacated around the overall site for it
(3) Some customers choose customized models that can be scribed, and special polypropylene special paint can be used to paint scribed lines and logos. Strong and not easy to fall off, the general color is white and easy to distinguish.
(4) The installation is relatively simple, usually two or three people can do it in about 3-4 hours. It will be faster if the customer buys half time.
(5) Each design has a very advanced anti-skid effect. For example, SES Elite and Elastic Star-ll are our best-selling styles, which are very distinctive and scientifically designed. The cross at the top has good drainage and the material is also very strong. Their advantages are pressure bearing and cushioning, while the cross at the bottom The support point has strong protection for the top, coupled with the design of the elastic pad or the stability of the multiple cross hollow support points, it can form a good contact with the ground without glue and will not slide freely.
(6) In addition, we need to reserve an area to put our basketball stand. Of course, we can also provide customers with different types of basketball stands in this part.
Installation method introduction
To install the pp tiles we purchased normally, there are two more convenient installation methods.
NO.1 starts the laying method with the upper left corner. First of all, we need to have a concept for our basketball court. We need to mark the four corners on the drawing, take the upper left corner as the base point, and spread it out to the right in a tiled manner. According to the entire installation direction, every time we install a After laying, you should always pay attention to whether there is any deviation, and you need to adjust it in time. If you feel that your sense of direction is not good, you can make a design picture before starting to lay, so it is much easier to follow it. The advantage of this laying method is that it is simple and clear, and it is relatively convenient to assemble. You only need to pay attention to the direction of the entire floor.
NO.2 Center-based laying method. This needs to measure the position of the center point of the entire court, and this fast floor should be regarded as the most important plate, so that the next steps will not go wrong. If you can't find the center point, you can use the cross rule to take the middle point of the length and width of the entire basketball court floor, and then the cross position is the center point. After setting the center point, expand and assemble the surrounding areas outside the center. We only need to align the horizontal and vertical without offsetting. This method is relatively simple, direct and efficient.
What materials are good for laying the ground in children's playgrounds?
Good materials for playgrounds--EPDM Construction
3v3 Basketball Floor Tiles Size and Installation
Basketball Court Tiles|Elasticity Advantage
